UAV jammer Drone interference, interference distance of 5 kilometers, interference of 5 frequency bands
Portable UAV jammer

Product introduction

1: The man portable UAV countermeasure equipment shall mainly interfere with the transmission link of unmanned aerial vehicles from home and abroad, interfere with and suppress the flight control signal and navigation positioning signal of the aircraft by transmitting directional electromagnetic wave, so as to achieve the purpose of interfering with various brands and models of civil unmanned aerial vehicles in the current market.

2: Portable UAV anti shield, the first to use digital frequency scanning technology, and then carefully developed portable UAV control products. The product belongs to green environmental protection type, and the backward radiation to human body is almost zero.

3: The reaction adopts 5-channel signal outputs (900MHz, 1.4GHz, 1.6GHz, 2.4GHz, 5.8GHz) to block the UAV link. After many low altitude airspace support practical battles, the product can react at a speed of 3 ~ 5km per second, so as to cut off the communication and navigation between the UAV and the remote control pilot from a long distance, drive or crash land the UAV, and effectively maintain the low altitude safety, All kinds of security threats caused by UAV in low altitude airspace have been guaranteed and successfully completed.

Product features

1：Imported chip generator is adopted in the product, and ultra-high speed digital frequency sweeping technology is applied to generate a variety of bandwidth signals.

2：Ultra wideband high gain integrated antenna and battery built-in design, simple and light, easy to carry and operate.

3: It adopts aluminum shell, intelligent temperature control and heat dissipation, and the surface adopts international technology secondary oxidation and wear resistance.

4: The effective reaction radius distance is 3km (urban environment), and the limit radius is 5km (open without interference).

5: Reaction mode: conventional signal, frequency modulation, spread spectrum control and other full frequency coverage, high-speed risk control.

6: The visible part of the body is equipped with a power switch, including a power indicator, which can be directly controlled by both hands.

7: The control switch is independently designed to control obstruction, displacement and forced landing for UAV.

Product parameters

Basic design concept

1: The equipment shall meet the portable requirements, and any one of length, width and height shall be ≤ 306mm.

2: It is equipped with a special portable magnesium aluminum alloy suitcase, which can be used in or out of the box. The equipment body and special work box meet the characteristics of ergonomics.

3: The equipment adopts integrated design and special battery power supply. The design of the battery compartment follows the safety design standards (with anti reverse plug and locked power connector, and a warning mark is marked at the obvious place of the battery compartment or equipment, and a warning statement is given in the relevant instructions).

4: The reaction form of the equipment is directional radio interference. The basic interference frequency bands include 900MHz (full band), 1.4GHz (full band), 1.6GHz (L1 band of the four global navigation systems), 2.4GHz (full band) and 5.8GHz (full band). The above five frequency bands (or more) can be interfered at the same time.

5: Transmission frequency: Channel 1: 829 ~ 939mhz, channel 2: 1350 ~ 1475mhz, channel 3: 1547 ~ 1673mhz, channel 4: 2398 ~ 2507mhz, channel 5: 5708 ~ 5854mhz. 7: Transmission power: Channel 1: 46.45dbm, channel 2: 46.76dbm, channel 3: 46.55dbm, channel 4: 45.88dbm, channel 5: 44.79dbm.

basic function

1: Directional launch: the launch direction is manually controllable.

2: Charging: the equipment can charge the battery through the equipped charging equipment. During charging, there will be obvious charging and completion status display. After completion, there will be protective measures to prevent overcharging.

3: Equipment performance: for UAVs with remote control frequencies of 900MHz, 1.4GHz, 1.6GHz, 2.4GHz and 5.8GHz, the interference distance is ≥ 3000m (when the UAV is 100m away from the remote controller in urban environment and 100m high).

4: Limit requirements: for UAVs with remote control frequencies of 900MHz, 1.4GHz, 1.6GHz, 2.4GHz and 5.8GHz, the interference distance shall be ≥ 5000m (when the UAV is 100m away from the remote controller in an open environment and 100m high).

5: Beam width: the horizontal plane and vertical plane of the transmitting half power angle are between 20 degrees and 40 degrees.

6: Working time: 30 seconds apart, 90 seconds off, and the total transmission time ≥ 1 hour (900MHz, 1.4GHz, 1.6GHz, 2.4GHz and 5.8GHz bands are turned on at the same time).

7: Continuous transmission ≥ 5 minutes (five frequency bands of 900MHz, 1.4GHz, 1.6GHz, 2.4GHz and 5.8GHz are turned on at the same time).

Power Supply

1: The battery performance shall comply with GB 31241-2014 safety requirements for battery packs of portable electronic products.

2: The equipment is powered by the standard configuration battery. The working time of the battery can meet the standby for 72 hours and can still meet the requirements of continuous transmission for ≥ 3 minutes (the five frequency bands of 900MHz, 1.4GHz, 1.6GHz, 2.4GHz and 5.8GHz are turned on at the same time).

3: The battery charging time is ≤ 3 hours after the total transmission time reaches 1 hour (900MHz, 1.4GHz, 1.6GHz, 2.4GHz and 5.8GHz bands are turned on at the same time).

4: Equipped with ordinary civil (220V) charger.

5: The response time of the main power switch key is ≤ 1 second.

6: Launch switch key response time ≤ 1 second.

7: Interference response time ≤ 2 seconds.

Operation guide

1: Before opening the box and taking out the equipment, check whether the accessories are complete.

2: Please fully charge the battery of the device for the first time. When charging, the battery is insufficient. The charger charging display light is bright red and the battery full indicator light is bright green. Please ensure that the battery is fully charged before use.

3: Displacement mode

Use the counter shield to face the direction of the UAV: press the on key (2.4GHz / 5.8GHz) and the indicator light is on. At the same time, drive the UAV away (return to the take-off point), and no one leaves the blocking jurisdiction to complete the counter attack.

4.: forced landing mode

Use the anti shield to face the direction of the UAV, press the on key (2.4GHz / 5.8GHz + 1.6GHz) and the indicator light will light up. At the same time, interfere with the UAV, and no one has the opportunity to land slowly at 70% throttle. Because GPS is blocked and interfered, it may drift and land with the wind in a windy state, which is a normal phenomenon.

5: Special frequency band

900MHz and 1.4GHz are UAVs for special transmission frequency band, which can be turned on or off as required.

BOM

1: Charger * 1

2: Equipment host strap * 1

3: Handheld anti UAV shield host * 1

4: Magnesium aluminum alloy handheld Box * 1